Easy ?T-80 Instrucciones de operaciones descargar pdf (Pagina 23)

Instructions for installers and service engineers only

INSTRUCTIONS FOR INSTALLERS AND SERVICE ENGINEERS ONLY

Instructions for installers and service engineers only

CLEANING THE FILTER

It is recommended that the filter is periodically

cleaned in order to maintain the performance of

the shower. It is essential that this operation is

carried out by a competent person.

IMPORTANT: Before servicing, switch off the

electricity supply at the mains.

• Switchoffthewatersupplyattheisolator

valve.

• Theinletfilterissituatedinsidethewaterinlet

fitting (ﬁg.21).

• To gain access to the ﬁlter, remove the cover

and bottom left trimplate.

• Unscrewtheltercapfromthebottomofthe

inlet pipe.

• Inspectthe‘O’ringfordamagewhenthe

filter cap is removed.

• Whencleaningthefilter,DO NOT use a sharp

object, as it will cause damage. It is preferable

to use an old toothbrush or similar.

• Toreassemble,followtheprocedurein

reverse.

• Makesurethatthesealing‘O’ringisinplace.

• DO NOT over tighten the filter cap on

reassembly.

NOTE: Full commissioning procedure will need

to be performed after cleaning of the filter - see

page 15 for information on commissioning

procedure.

Fig.21

Filter

assembly

‘O’ ring

Inlet

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Sin comentarios

Easy ?T-80 Instrucciones de operaciones Pagina 23