Easy ?T-80 Instrucciones de operaciones descargar pdf (Pagina 15)

• Hookthebackplateoverthetopscrewand

fit the bottom fixing screws into position,

but DO NOT fully tighten the screws at this

stage. The fixing holes are elongated to

allow for out of square adjustment after the

plumbing connection has been completed.

• Connectthemainswatersupplytotheinlet

DO NOT use excessive force when making

the connection.

• Makesurethebackplateissquareonthe

wall and tighten the retaining screws which

hold it to the wall.

• Turnonthemainswatersupplyandcheck

for leaks in the pipework connection to the

shower.

NOTE: At this stage no water can flow through

the unit.

IMPORTANT: A suitable sealant should always

be used to seal around the incoming pipework to

prevent water entering the wall.

Continued

SECTION

Fig.10

Fixing holes

WARNING

Check there are no hidden cables or

pipes before drilling holes for wall plugs.

Use great care when using power tools near

water. The use of a residual current device

(RCD) is recommended when

using power tools.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Sin comentarios

Easy ?T-80 Instrucciones de operaciones Pagina 15